Above Ground Pool Pump Not Working Properly

Make sure the water level in the pool is sufficient and air is not being sucked in through skimmer inlets.

Above ground pool pump not working properly.

Trust me on this. It may work for a couple of seconds but then it stops. The pump seems to work fine but when we connect the vacuum the suction decreases drastically. Insufficient power is the most common culprit.

The good new is it s pretty straight forward just follow the steps below. Verify that the pump strainer. In other words it has lost its prime. If you are experiencing a heatwave contact your power company to see if this could be an issue.

Relieve any existing pressure by turning the air relief valve counter clockwise on your pool filter until the. There is nothing clogging the filter or the hoses. If the pump strainer is not full of water and an air leak has been ruled out your pump may not be fully primed. A pool pump can be primed by following these fairly simple steps.

Turn the air relief valve on the pool filter clockwise to relieve any existing pressure the pressure reading on the. Pool pump not turning on. There can be several reasons for an above ground pool pump to run hot. The pump runs but isn t pumping.

Add water to the pool to submerge the skimmers if necessary. Disconnect any power to the pump and move the diverter valve so that the main drain side is turned to off. In this article we will look at some of the major issues that may prevent pool pumps from working. With the pump off remove the lid and fill the strainer with water.

I m not sure whats happening but we can t get the pool clean. This can happen in areas where power is drained from the local power grid during prime hours. Above ground pool pumps are very easy to operate since they have a simplified design but just like other systems they also encounter problems and sometimes they may not be able to pump water as required. Keep the water running for a couple minutes.

It could be okay. Don t toss that pool pump motor until you try this simple trick to see if you can get it going. This will allow the pipes to fill with water. This could mean an obstruction dirty pool filter or too much air getting into the plumbing system.

Cut off the main drain by turning the diverter valve. Any help would be great. The filter is new and the pump is fairly new not even a year old and it wasn t even used that long.